TM 5-3805-296-23-1
0035
Table 1. 0548 Throttle Lock Diagnostic Codes Continued.
035
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Test Step 7. Test Ground Circuit
0548-05 Throttle Lock Lamp
Function.
Current Below Normal
Continued
Proceed to Test Step 8.
measure resistance between
connector W-C7 terminal 38
Replace main cab wiring harness
(WP 0505).
Proceed to Test Step 8.
Test Step 8. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
3. At MSD, check for active
548-5 Throttle Lock Lamp Current
Below Normal Becomes Inactive
Proceed to step 4.
548-5 Throttle Lock Lamp Current
Below Normal Remains Active
Repeat troubleshooting from the
beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. If removed, install splash shield
(Figure 2, Item 4), four bushings
(Figure 2, Item 3), washers
(Figure 2, Item 2), and bolts
(Figure 2, Item 1) on machine.
6. If lowered, install left frame access
plate (WP 0376).
7. If removed, install step
(Figure 3, Item 3), six washers
(Figure 3, Item 2), and bolts
(Figure 3, Item 1), on cab
(Figure 3, Item 4).
8. If removed, install lower and upper
plenum on ROPS (WP 0504).
9. Troubleshooting complete.
0035-7