TM 5-3805-296-23-1
0017
Table 1. 0005 Fuel Injector Diagnostic Codes Continued.
017
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0005-06 Cylinder #5 Injector
Current Above Normal
Continued
Figure 9. Splash Shield and Retaining Hardware.
0017
4. Disconnect connector CM-C1
(WP 0012, Figure 30) from engine
ECM.
5. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 107 (WP 0012, Figure 30)
No Continuity Proceed to step 6.
and all other terminals
in connector CM-C1
(WP 0012, Figure 30).
6. Using digital multimeter
Continuity Replace basic engine
(WP 0540), measure resistance
wiring harness (WP 0251).
between connector CM-C1
Proceed to Test Step 4.
terminal 107 (WP 0012, Figure 30)
No Continuity Replace engine ECM
and ground.
(WP 0252).
Proceed to Test Step 4.
Test Step 4. Verify Malfunction is
Resolved.
1. Ensure all harness connectors are
connected.
2. Ensure valve cover is installed on
engine (WP 0182).
3. Turn battery disconnect switch to
ON position and start engine or
attempt to start engine
(TM 5-3805-296-10).