TM 5-3805-296-23-1
0015
Table 1. 0003 Fuel Injector Diagnostic Codes Continued.
015
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
4. Disconnect connector CM-C1
0003-05 Cylinder #3 Injector
(WP 0012, Figure 30) from engine
Current Below Normal
ECM.
Continued
5. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Replace engine ECM (WP 0252).
between connector CM-C1
Remove jumper wire from terminal 3
terminal 106 and terminal 115
and terminal 8 of connector CM-C13
(WP 0012, Figure 30).
(WP 0012, Figure 14).
Proceed to Test Step 4.
Resistance Greater Than 5.0 Ohms
Replace basic engine wiring harness
(WP 0251).
Remove jumper wire from terminal 3
and terminal 8 of connector CM-C13
(WP 0012, Figure 14).
Proceed to Test Step 4.
Test Step 3. Test Engine Injector
Wiring Harness for High Resistance
or Open.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
2. Remove valve cover (WP 0182).
3. Disconnect connector CN-C5
(WP 0012, Figure 8) from fuel
injector #4 (WP 0012, Figure 7).
4. Disconnect connector CN-C4
(WP 0012, Figure 6) from fuel
injector #3 (WP 0012, Figure 5).
5. Remove jumper wire from terminal
3 and terminal 8 of connector
CM-C13 (WP 0012, Figure 14).
6. Connect jumper wire between
terminal 3 and terminal 8
of connector CN-C1
(WP 0012, Figure 13).
0015-7