TM 5-3805-296-23-1
0007
MODES OF OPERATION
0007
The machines' monitoring system has eight modes of operation. Each mode provides important information
regarding the condition of the machine. The operating modes are accessible by the Mode Select Switch (Figure 2,
Item 6) that is located in the Operator's compartment. The following table shows the available modes:
Table 4. Operating Modes.
0007
Operating Modes Tractor
Mode 1
Total machine operating hours
Service Meter
Total distance the machine has traveled
Mode 2
Odometer
Mode 3
Engine RPM
Digital Tachometer
Mode 4
Machine's diagnostic codes are displayed
Scrolling
Mode 5
Quad gauge readings are shown more accurately in
Numeric Readout
normal mode
Mode 6
6.1 Engine inlet air temperature
Tractor Engine Parameter Display
6.2 Engine fuel filter status
6.3 Engine inlet air pressure
Mode 7
7.1 Transmission pilot air supply pressure
Tractor Transmission Parameter Display
7.2 Transmission top gear (Programmable)
Mode 8
8.1 Hydraulic oil temperature
Machine Control Parameter Display
The mode of operation is variable at any time. Pushing the Mode Select Switch (Figure 2, Item 6) initiates the
scrolling of the mode numbers. Releasing the Mode Select Switch (Figure 2, Item 6) causes the monitoring system
to enter the operating mode. The mode number that is shown will correspond to the operating mode. When
scrolling through the modes, mode 0 (normal mode) is not shown on the display area as a number. When mode 0
is reached, the display area begins showing the information for mode 0 (normal mode).
END OF TASK
END OF WORK PACKAGE