TM 5-3805-296-10
0001
PREPARATION FOR STORAGE OR SHIPMENT CONTINUED
0001
Inspection. Inspect and approve the equipment prior to storage. Do not place non-mission-capable equipment in
storage.
Correction of Shortcomings and Deficiencies
0001
0001
Correct all shortcomings and deficiencies prior to storage, or obtain a deferment from the approving authority.
Lubrication. Lubricate equipment in accordance with LO 5-3805-296-13.
0001
General Cleaning, Painting, and Preservation
0001
0001
C AU T I O N
Do not direct water or steam, under pressure, against electrical wires or any exterior
opening. Failure to follow this caution may result in damage to equipment.
Cleaning. Clean all equipment of dirt, grease, and other contaminants in accordance with applicable provisions of
this manual. Do not use vapor degreasing.
WARN I N G
The following must be done before grinding, cutting, or welding any equipment that has
been CARC-coated:
Wear protective equipment (e.g., goggles, gloves, apron) when grinding or
sanding CARC-coated equipment. Do not leave any skin exposed.
Use high-efficiency air purifying respirators when grinding or sanding CARC-
coated equipment.
Never weld or cut CARC-coated equipment, grind or sand off CARC paint
completely before welding.
CARC paint contains isocyanate (HDI) which is highly irritating to skin and
respiratory system high concentrations of HDI can produce symptoms of itching
and reddening of skin, a burning sensation in throat and nose, and watering of the
eyes. In extreme concentrations, HDI can cause coughing, shortness of breath,
pain during respiration, increased sputum production, and chest tightness.
Failure to follow these wanings may result in injury or death to personnel.
r
Painting. Remove rust and damaged paint by scraping, wire brushing, sanding, or buffing. Sand to a smooth finish
and spot paint as necessary (TB 43-0209).
0001-3
