TM 9-6230-210-13&P
(a)
(b)
(c)
(d)
Lower tower assembly (1) into position in tower cradle (2) and align pivot hinge (3) with mounting holes
on splash panel (4).
Secure assembly with lockwashers (5) and nuts (6).
NOTE
Bolts are welded to pivot hinge.
Thread cable (7) through pulley (8) at base of tower support.
Wrap cable from beneath the pinion shaft (9) a minimum of three wraps.
LEGEND
1 CARRIAGE
BOLT
2 KEEPER
3 WASHER
NOTE
Be sure that the carriage bolt heads are on the inside of the drum.
(e) From inside of drum, thread the calbe through one round hole in the drum side, until it extends 1-inch (2.54
cm) past the two square holes. Then clamp the cable to the outside of the drum with carriage bolts (1),
rope keeper (2), lockwashers (3) and nuts (4).
(5) Light bar and red warning light.
4-10