TM 9-6230-210-13&P
SECTION III. OPERATOR’S MAINTENANCE PROCEDURES
3.4 FLOODLIGHT
ASSEMBLY.
This task covers: a. Service
b. Replace
INITIAL SETUP
Materials/Parts
Equipment Condition
Soap (item 20, appx E)
Tower in horizontal position (para 2.7)
Water
Rags (item 18, appx E)
General Safety Instructions
WARNING
Personnel Required
HIGH VOLTAGE
MOS 63B Lightweight Vehicle and Power Generation
Disconnect power supply before servicing. High
Mechanic
voltage is carried in floodlight assembly. Electrical
shock could seriously injure you and may even
cause death.
SERVICE
LEGEND
1 POWER CORD
2 JUNCTION BOX
3 PLUG
4 TEE BOLT
5 FLOODLIGHT
6 LIGHT BAR
DO NOT use acid or caustic compounds to clean lens or reflectors. Equipment dam-
age could result.
a. Disconnect power cord (1) from junction box (2) by removing plug (3).
b. Loosen three T-bolts (4) and remove floodlights (5) from light bar (6). Place on flat surface.
c. Service floodlight assembly by cleaning lenses. Use clean rags, soap, and water to clean lenses. Dry thoroughly.
3-11
