11
2
10
9
2
TM 9-4940-568-34
5-89
e.
Assembly.
(1)
Apply lubricating oil to copper seal (13) and
position copper seal on injector (2).
f.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
(1)
Apply light coat of anti-seize compound to
threads of injector hold down nut (11) and
between top of nut and injector body (2).
Align injector with notch in the
bore.
(2)
Position injector (2) in cylinder head and
hold body of injector with wrench.
NOTE
One type of injector has a
preformed packing located above
the hold down nut. After
tightening the injector be sure to
push the preformed packing into
the groove.
(3)
Tighten injector hold down nut (11) to 44
lb-ft (60 N.m).
(4)
Install banjo seal (10) and banjo fitting
screw (9) on fuel injector (2).
