TM 9-4940-568-20
2-2
Section I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT AND
DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE)
applicable to your unit.
2-2. SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT.
For a listing of special tools, TMDE and support equipment, refer to the Maintenance Allocation Chart (MAC),
Appendix B, of this manual and to the Repair Parts and Special Tools List (RPSTL).
2-3. REPAIR PARTS.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List (RPSTL) covering Unit Maintenance for
this equipment.
Section II. SERVICE UPON RECEIPT
2-4. UNPACKING AND DEPROCESSING.
a.
Unpacking. Upon receipt of a new FRS, the receiving organization must see if it has been properly
prepared for service and is in good condition. Inspect all assemblies, subassemblies and accessories to be sure
they are in proper working order (TM 9-4940-568-10). Secure, clean and correctly adjust and/or lubricate as
needed (Para 2-9 and TM 9-4940-568-10). Check all tools and equipment to be sure every item is accounted for
(SC 3990-CL), in good condition, clean and properly mounted or stowed (TM 9-4940-568-10).
b.
Deprocessing. Read “Processing and Deprocessing Record of Shipping, Storage and Issue of FRS” tag,
(DD Form 1397), and follow all precautions checked. This tag should be attached to the generator control panel
access door.
2-5. HAND RECEIPT MANUAL AND INVENTORY OF EQUIPMENT.
When a new FRS is first received by the using organization, it is necessary to inventory the equipment. For detailed
procedures, refer to Supply Catalog, SC 3990-CL.
2-6. SERVICE BEFORE OPERATION.
a.
General.
(1)
Refer to TM 9-4940-568-10 for operating instructions for the FRS.
