6
8
7
4
5
7
3
3
TM 9-4940-568-20
4-9
(2)
Remove screw (4), washer (5), and safety
catch (6) from upper support arm (3).
NOTE
The following procedures are
identical for all upper and lower
support arms.
Note position of setscrew prior to
removal.
(3)
Remove jam nut (7) and setscrew (8) from
upper support arm (3).
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all parts with drycleaning solvent.
(2)
Inspect parts for breaks, cracks, burrs, and sharp edges. Look for unusual signs of wear on the support
arm bolt holes and gear teeth.
