TM 9-2330-389-14&P
APPENDIX H
TORQUE LIMITS
H-1. SCOPE.
This appendix lists standard torque values, as shown in Table H-1, and provides general information for applying torque.
Special torque values and tightening sequences are indicated in the maintenance procedures for applicable components.
H-2. GENERAL
a.
Always use the torque values listed in Table H-1 when the maintenance procedure does not give a specific torque
value.
b.
Unless otherwise indicated, standard torque tolerance shall be 10%.
c.
Torque values listed are based on clean, dry threads. Reduce torque by 10% when engine oil is used as a
lubricant. Reduce torque by 20% if new plated capscrews are used.
d.
Capscrews threaded into aluminum may require reductions in torque of 30% or more of Grade 5 capscrews
torque and must attain two capscrew diameters of thread engagement.
H-1
