TM 9-2330-359-14&P
5-1. BRAKESHOE REPAIR (Con’t).
b .
CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent’s flash point is 100°F-138°F (38°C-59°C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, Immediately wash your eyes and get medical aid.
1.
Clean brakeshoes with dry cleaning solvent and a wire brush. Allow to air dry.
2.
Inspect brakeshoes for cracks and breaks.
c.
BRAKESHOE LINING INSTALLATION
WARNING
Replace brakeshoes if cracked or broken.
If any brakeshoes are replaced, replace all
brakeshoes on that axle. Combination of old
shoes with new shoes wiII cause uneven brak-
ing. Accidents causing serious injury or death
to personnel or damage to equipment may re-
suit.
NOTE
All brakeshoe linings are installed the same
way except quantity of rivets may vary.
Install brakeshoe linings (2) on brakeshoe (3) with
twenty-four new rivets (1).
FOLLOW-ON TASKS:
. Install brakeshoes (para 4-31).
l Adjust service brakes (para 4-31).
5-2
TA508076
