TM 9-2330-359-14&P
4-30. AXLE MAINTENANCE (Con’t).
5.
Install camshafts and brakeshoes (para 4-32 or 4-33 and para 4-31).
6.
Install hubs and brakedrums (para 4-44), but do not install outer wheels.
e.
AXLE ALINEMENT
1.
2.
3.
4.
5.
6.
NOTE
Ensure that semitrailer is unloaded and level from side to side and from front to rear.
Measure distances “A” and “B” from kingpin to axle spindles. Measurements should be within ~ in. (3.2 mm) of
each other.
Measure distances “C” and “D” between axle spindles. Measurements should be within ~ in. (3.2 mm) of each
other.
Measure distances “E” and “F” between axle spindles. Measurements should be within ~ in. (3.2 mm) of each
other.
NOTE
Perform step 4 If Improper measurements were obtained In steps 1 through 3.
Loosen two nuts (17) on radius rod (18) and turn radius rod to adjust. Ensure that nuts are tightened when
alinement is obtained.
if true alinement cannot be obtained, inspect and replace worn or bent suspension parts, or replace affected
axle (para 4-30, 5-11, 4-54, or 5-12).
Install outer wheels (para 4-46).
4-44
Change 2
