TM 9-2330-324-14&P
0086 00-1
TORQUE LIMITS
0086 00
SCOPE
This WP lists standard torque values (Table 1) and provides general information for applying torque.
Special torque values and tightening sequences are included in the maintenance procedures for
applicable components.
GENERAL
Always use the torque values listed in Table 1 when the maintenance procedure does not give a specific
torque value.
Unless otherwise specified, standard torque tolerance shall be ±10%.
Torque values are based on clean, dry threads. Reduce torque by 10% when engine oil is used as a
lubricant. Reduce torque by 20% if new plated capscrews are used.
Capscrews threaded into aluminum may require reductions in torque of 30% or more of Grade 5
capscrew torque. Capscrews threaded into aluminum must also attain two capscrew diameters of thread
engagement.
CAUTION
If replacement capscrews are of a higher grade than originally supplied, use torque
specifications for the original. This will prevent equipment damage due to
overtorquing.
