TM 9-2330-238-14
4-64. BONNET FRONT DOOR LINKAGE REPLACEMENT (M313 AND M447C) (Con’t).
3.
From inside van body, remove cotter pin (9) from
rear end of connecting link/control rod (3).
Remove connecting link/control rod from door
handle (6). Discard cotter pin.
4.
If bonnet register control rod (11) is present,
remove cotter pin (1 O). Remove bonnet register
control rod from connecting link/control rod (3).
Discard cotter pin.
5.
Remove connecting link/control rod (3) carefully
through rubber bellows seal,
6.
Remove nut (8), Iockwasher (7), door handle (6),
and spacer (13) from post assembly (12). Discard
Iockwasher.
b.
INSTALLATION
1.
Position spacer (13), door handle (6), and new Iockwasher (7) on post assembly(12) and secure with nut (8).
2.
Carefully insert connecting link/control rod (3) through rubber bellows seal.
3.
Connect end of connecting link/control rod (3) through door handle (6) and install new cotter pin (9).
4.
If removed, connect bonnet register control rod(11 ) to connecting link/control rod (3) and install new cotter pin
(lo).
5.
Connect front end of connecting link/control rod (3) with door angle bracket (4) and install new cotter pin (5).
6.
Close bonnet front door (l).
TA702026
4-149
