TM 55-8115-203-23 & PGLOSSARYBevel- To cut or grind an edge at an angle other than ninety degrees.Continuous weld - A weld extending the full length of a seam, without any break (or skip).Corrugation- Steel panel folded in a regular pattern for maximum structural strength.Crossmember- A C-beam supporting the container floor.Flange- The horizontal section of a C-beam.Horizontal- Side to side.J-bar- Part of each front corner post to which door hinges are attached.Kickplate- Aluminum plate inside container which protects plywood liner.Pin hole- Very small hole which may form in a bad weld.Placard- Hazard warning sign kept in place on the container by a placard holder.Shielding- In welding, any material used to protect heat sensitive materials from the welding frame or are.Skip weld- Method of welding in which the seam is welded for an inch, not welded, (or skipped) for an inch, welded,skipped, and so on.Tek-dek- Reinforced fiberglass material installed as flooring on many of the cargo containers.Vertical- Up and down.Vertical web- Up and down portion of the cross member.Glossary 1/(Glossary 2 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business