TM 5-4930-244-14
(c)
Inspect all parts for damage. Replace as required.
(3)
Installation.
(a)
Install adjusting screw (28) through rocker arm assembly (7) and secure adjusting screw (28) with
locking nut (29).
(b)
Install shaft (21) and bushing (27) into lever (20).
(c)
Install new preformed packing (26) on shaft (21).
(d)
Push shaft (21) into cylinder head (9).
(e)
Install spring pin (24) into shaft (21).
(f)
Install studs (22) into cylinder head (9).
(g)
Position new gasket (17) on crankcase (18).
(h)
Install two screws (15) and housing (16) onto crankcase.
(i)
Position gaskets (25) and cylinder barrel (14) onto crankcase (18).
(j)
Use stud remover/setter to install fire studs (5) into cylinder barrel (14).
(k)
Position new gasket (13) on cylinder barrel (14).
(I)
Install two tubes (11) and four new seals (12). Position cylinder head (9) on cylinder (14).
(m)
Lubricate two push rods (10) with oil. Install push rods (10) into cylinder head (9).
(n)
Install new o-ring (8) and rocker arm assembly (7).
(o)
Loosely install fire nuts (4) and washers (6)
(p)
Torque nuts (4) between 20 ft-lbs (27.0 Nm) in sequence shown in detail.
(q)
Adjust intake and exhaust valves and decompression lever (Reference para. 5-10.n.).
(r)
Align holes in new gasket (3), cylinder head (9) and cover (2).
(s)
Install two screws (1) to secure cover (2) to cylinder head (9).
5-60
