TM 5-4930-244-14
(9)
Disconnect hydraulic hose assembly (6) end fitting.
(10)
Remove hose clip (8) and hydraulic hose assembly (6) from trailer frame (9).
(11)
Remove two self-locking nuts (10), two pan head machine screws (11), two cushioned cable clamps (12), from
brake lines (7 and 13) and trailer frame (9). Discard nuts.
(12)
Holding brake line coupling (14) with wrench, disconnect brake line (7) from brake line coupling (14).
(13)
Holding brake line coupling (14) with wrench, disconnect brake line (13) from brake line coupling (14).
(14)
Loosen brake line (13) at adapter (15) and allow brake fluid to drain from master cylinder (16) into cup or other
suitable container.
(15)
Holding adapter (15) with wrench, disconnect brake line (13) from adapter (15).
(16)
Inspect all parts for any deterioration or damage. Replace if necessary.
WARNING
·
Dry cleaning solvent is flammable and toxic. Keep solvent away from open
flames or sparks. Avoid inhaling solvent fumes. Avoid contact with skin.
(18)
Clean all threads and fittings with dry cleaning solvent Wipe clean using wiping rags.
b. Installation.
NOTE
Before installation wrap threads on brake line fittings with Teflon Tape where
needed.
(1)
Connect brake line (13) into adapter (15).
(2)
Holding brake line (13) fitting with wrench, install brake line coupling (14) onto brake line (13). Tighten brake line
coupling (14).
(3)
Holding brake line coupling (14) with wrench, install brake line (7) onto brake line coupling (14). Tighten brake
line coupling (14).
(4)
Slide two cushioned cable clamps (12) onto brake lines (7 and 13). Align the two cushioned cable clamps (12)
with holes in frame (9). Install two pan head machine screws (11) through holes in frame (9), securing it using
two self-locking nuts (10). Tighten.
4-170
