TM 5-4930-244-14
(k)
Remove lead from terminal (3) on solenoid (6).
(I)
Remove two screws (21) and two lockwashers (22) holding starter solenoid (6) Discard two lockwashers.
(m)
Pull starter solenoid (6) off of starter (4).
(3)
Installation.
(a)
Install starter solenoid (6) into position on starter (4).
(b)
Install two new lockwashers (22) and two screws (21) onto starter (4) to hold starter solenoid (6) in place
(c)
Install starter (4) into position on engine (5).
(d)
Install three cap screws (19), and three lockwashers (20) onto engine (5), to hold starter (4) in place.
(e)
Place positive battery lead (16) and wire #28 onto starter terminal (2).
(f)
Install and tighten nut (17) and washer (18) onto battery terminal (2).
(g)
Plug starter switch lead (15), which has wire #26, onto starter terminal (1).
(h)
Install hose (10), and tighten two clamps (9)
(i)
Install alternator (para 4-32)
(j)
Install alternator belt guard (para. 4-31).
(k)
Install engine air intake hose (8) and tighten two hose clamps (7)
(I)
Install lube tank duct (11) to heat inlet (13) and heater plenum (12), and tighten two clamps (14)
(m)
Reconnect negative battery lead to battery post (para 4-26).
4-109
