TM 5-4930-244-14
WARNING
·
Diesel engine is heavy. Exercise caution when lifting or moving the diesel
engine. Injury could occur. Use two people to lift.
(j)
Remove diesel engine (3) and set it on blocks or other suitable surface. Diesel engine (3) must be moved
by two personnel.
(3)
Installation.
(a)
Set diesel engine (3) onto air-receiver tank mount (20), aligning up holes.
(b)
Install four nuts (17) under air-receiver tank mount (20), four washers (18), and bolts (19), through diesel
engine (3) mount.
(c)
Install bolt (14), washer (15), and two ground wires (16) to diesel engine (3).
(d)
Position hose (12) on air cleaner (13), securing with clamp (11).
(e)
Connect electrical lead (8) to glow plug (10), securing with nut (9)
(f)
Install oil temperature switch (7) into diesel engine (3)
(g)
Connect fuel line (5) to suction side of fuel pump (6) and tighten clamp (4).
(h)
Reconnect negative (ground) battery cable (para 4-26).
b. Air Cleaner Assembly.
(1)
Removal. (Refer to Figure4-31).
(a)
Remove hose from air cleaner (para 4-39.a.). Remove breather tube (7) from valve (9)
(b)
Remove two nuts (1) and two washers (2) from studs (3)
(c)
Remove air cleaner assembly (4) and gasket (5) from cylinder head.
(2)
Disassembly.
NOTE
For Removal, see para. 4-39.b.(1).
(a)
Slide clip (6) down on breather tube (7). Remove breather tube (7) from breather (8). Remove breather (8)
from manifold (10).
(b)
Loosen clamp (11) on end of air cleaner housing (12) and grommet (13). Slide air cleaner housing (12) and
grommet (13) off of manifold (10)
(c)
Release toggle clips (14) on both sides of air cleaner housing (12) and remove air cleaner cap (15), seal
(16), and element (17).
4-103
