TM 5-4930-244-14
c.
Installation. (Refer to Figure 4-17).
(1)
Install battery tray supports (41) by installing pan head screws (40) and new self-locking nuts (39).
(2)
Install battery tray plate (38) into battery box (14).
(3)
Install rubber battery tray (37) onto battery tray plate (38), In battery box (14).
(4)
Using rope handles (36) install front battery (34) into battery box (14); fold down rope handles (36) and slide
battery forward until it is against front of battery box (14).
(5)
Using rope handles (32) install rear battery (33) making sure that it clears front battery (34) and rear of battery box
(14) (6) Slide battery retainer (30) onto the two socket head, cap screws (31) in the rear of the battery box (14).
NOTE
Perform next step on both sides of battery retainer.
(7)
Install wire assembly (6) to left side of battery box (14), by installing hex head cap screw (29) and washer (28)
through outside of battery box (14) through battery retainer (31) and wire assembly. Install other washer (28) and
new self-locking nut (27).
(8)
Replace thermostat (23) to rear of battery box (14), by installing two pan head machine screws (26) two washers
(25) and two hex nuts (24).
(9)
Install solenoid (7) to left side of battery box (14), using two bolts (11), four washers (12) and two nuts (13).
(10)
Install damper (10) to left side of battery box (14), by installing shoulder screw (18), washer (17), washer (16) and
self-locking nut (15).
(11)
Install pins (8 and 9) through end of solenoid (7) and damper (10).
(12)
Install angle stop (22) on left side of battery box (14), by installing hex head cap screw (21), washer (20) and
locknut (19).
(13)
Attach wire (6) and wire (5) onto solenoid (7). Attach wire (5) to thermostat (23).
(14)
Connect quick-slide connector (42) of cord assembly (43) to thermostat electrical connector.
NOTE
For Installing battery box into reel cabinet assembly, reference para. 4-26.
4-64
