TM 5-4930-244-14
4-22. TOOL BOX ASSEMBLY - REPLACE/REPAIR.
This Task Covers:
a.
Removal
b.
Repair
c.
Installation
Initial Setup:
Tools Required
Tool Kit, General Mechanic's: Automotive (Appendix B, Section II, Item 1).
Tool Kit, Common Number 1 (Appendix B, Section II, Item 2).
Electric Drill, 3/16" drill bit (Appendix B, Section III, Item 2).
Materials Required
Rivets (Appendix H, Section II, Item 1).
Equipment Condition
Enclosure Assembly Removed (para. 4-13)
Unit shut down and cool.
Tool Box empty.
Personnel Required
2
a.
Removal. (Refer to Figure 4-11.)
(1)
Remove four nuts (5), from bottom of skid (6) and four bolts (7) and four washers (8) from bottom of tool
box assembly(4).
(2)
Remove bolt (9), washer (10) from inside of tool box assembly (4) and remove negative wire (11) and nut
(12) from tab on heater stand (13).
(3)
Remove tool box assembly (4) from skid (6).
b.
Repair.
(1)
Inspect tool box for dents, cracked welds, or any deterioration. Repair as needed.
(2)
Drill out rivet (14) from tool box assembly (4) using electric drill and 3/16" drill bit. Remove pad lock with
chain (1). Discard rivet (14).
(3)
Install rivet (14) through padlock chain into tool box assembly (4).
c.
Installation.
(1)
Align holes in tool box assembly (4) with holes in skid (6).
(2)
Install four bolts (7) and washers (8) through bottom of tool box assembly (4) through skid (6) and attach
four nuts (5).
(3)
Install bolt (9), washer (10) through back of tool box assembly (4), tab on heater stand (13), and negative
wire (11). Securing it with nut (12).
4-39
