TM 5-4930-244-14
(16)
Loosen and remove cap screw (41), two washers (42), and self-locking nut (43) securing trouble light
assembly (40) to A-frame (6). Discard self-locking nut (43).
(17)
Loosen and remove cap screw (44), two washers (45), and self-locking nut (46) securing strap (47) to A-
frame (6) Discard self-locking nut (46)
b.
Repair.
Replace any part that shows obvious wear or damage.
c.
Installation.
(1)
Position and align hole in securing strap (47) with hole in A-frame (6) Install cap screw (44), two washers
(45), and new self-locking nut (46) to A-frame (6).
(2)
Position trouble light assembly (40) with A-frame (6). Install cap screw (41), two washers (42), and new
self-locking nut (43), securing trouble light assembly (40) to A-frame (6)
(3)
Reconnect trouble light assembly (40) wires White wire connects to black and black wire connects to white.
(4)
Align holes in bracket (20) up with holes in A-frame (6) Install two bolts (39), four washers (38), and two
new self-locking nuts (37) securing bracket (20) to A-frame (6)
(5)
Connect hose (36) to swivel (35) at reel cabinet assembly.
(6)
Connect hose (34) to swivel (33) at reel cabinet assembly
(7)
Connect two swivel adapters (31) to connector (32).
(8)
Put clamps (16) on hose (17)
(9)
Align two clamps (16) up with holes in A-frame (6) Install two bolts (13), four washers (14) and two new self-
locking nuts (15), securing clamps (16) to A-frame (6)
(10)
Connect coupling (21) to swivel adapter (22) on high pressure pump (23).
(11)
Screw swivel adapter (18) onto nipple (19) and hose (17).
(12)
Connect hose (26) to swivel adapter (30)
(13)
Put clamps (25) on hose (26)
(14)
Align two clamps (25) up with holes in A-frame (6) Install two self-tapping screws (24), securing clamps (25)
to A-frame (6)
(15)
Connect coupling (27) to low pressure pump swivel adapter (28) on low pressure pump (29).
(16)
Put clamps (4 and 8) on hose (5).
(17)
Align clamp (4) up with hole in A-frame (6). Install bolt (3), two washers (2) through A-frame (6) and clamp
(4) Install new self-locking nut (1), securing clamp (4) to A-frame (6).
(18)
Align clamp (8) up with hole in A-frame (6) Install self-tapping screw (7) into A-frame (6), securing clamp to
A-frame (6).
(19)
Connect hose (5) to swivel adapter (12).
4-27
