TM 5-3820-245-14&P
2-9. EQUIPMENT PUBLICATIONS
a. Equipment publications initially will be manufacturer's commercial manual (see appendix A). Two manuals are
overpacked and shipped with each end item.
b. After initial distribution, manuals normally will be Department of the Army (DA) authenticated and become
available from the Adjutant General (TAG).
c. If DA authenticated publications are not available, additional commercial manuals may be obtained by
requisitioning from Defense Construction Supply Center (DCSC). Requisitions to DCSC should be prepared in the same
manner as for part numbered repair parts, using the Federal Supply Code Manufacturer's (FSCM) and manual number
listed in appendix A. If DD Form 1348-6 is used, mail it direct to Commander, Defense Construction Supply Center,
ATTN: DCSC-OSR, Columbus, Ohio 43215.
d. The Army Equipment Maintenance System (TAMMS) TM 38-750 applies.
2-10. FACILITIES
No special maintenance facilities are required for the auger.
2-11. LOGISTICS ASSISTANCE (AR700-4)
US Army Tank-Automotive Command's Field Maintenance Technicians stationed at CONUS and OCONUS installations
are available to furnish on-site training and/or technical assistance. When training-or technical assistance is required
contact the appropriate Logistics Assistance Office (LAO) listed in appendix B, AR700-4.
9
