TM 5-3820-245-14&P
PROCEDURE FOR RESTORING AN ENGINE TO SERVICE WHICH HAS BEEN IN EXTENDED STORAGE
1.
Remove the covers and tape from all of the openings of the engine, fuel tank, and electrical equipment. DO
NOT OVERLOOK THE EXHAUST OUTLET.
2.
Wash the exterior of the engine with fuel oil to remove the rust preventive.
3.
Remove the rust preventive from the flywheel.
4.
Remove the paper strips from between the pulleys and the belts.
5.
Remove the drain plug and drain the preservative oil from the crankcase. Reinstall the drain plug. Then refer to
Lubrication System in the Operating Instructions and fill the crankcase to the proper level with the recommended
grade of lubricating oil.
6.
Fill the fuel tank with the fuel specified under Diesel Fuel Oil Specifications.
7.
Close all of the drain cocks and fill the engine cooling system with clean soft water and a rust inhibitor. If the
engine is to be exposed to freezing temperatures, add a high boiling point-type antifreeze solution to the cooling
system (the antifreeze contains a rust inhibitor).
8.
Install and connect the battery.
9.
Service the air cleaner as outlined under Air System.
PAGE 180