TM 5-3820-245-14&P
1-6
SERVICE UPON RECEIPT OF MATERIAL
A.
Inspecting and Servicing the Earth Auger
NOTE: Make certain the Earth Auger is completely depreserved before operating. Make sure
preservatives have been removed from the crankcase and fuel tank when required.
1.
Inspection. Visually inspect the Earth Auger for loss of parts or damage which may have occurred
during loading, shipping, or unloading. Check Earth Auger identification for positive identification of
Earth Auger.
2.
Service. Fill the radiator with coolant. Fill the fuel tank with diesel fuel. Lubricate according to
Lubrication Chart, Chapter 4-13. Open the battery box, fill battery per Chapter 4-15.
B.
Installation of Auger onto Carrier
THIS EQUIPMENT MUST BE INSTALLED INTO PROPER TRUCK CHASIS FOR
WARNING
SAFE OPERATION BOTH ON AND OFF ROAD. USE: TRUCK, CARGO, 5 TON, 6X6
M54AZ W/W
DO NOT USE A LIFTING DEVIC WITH LESS TAHN 15,000 POUND CAPACITY.
WARNING
NOTE: Tailgate must be removed from body of truck before installation of auger.
1.
Attach suitable lifting device to three lifting eyes on auger.
2.
Position auger over carrier.
3.
Slowly lower the auger to the carrier and mount as shown in Figure 1-2.
PAGE 7
