TM 5-3805-296-23-5
0371
INSTALLATION CONTINUED
4. Install retainer (Figure 8, Item 2) on rear tire wheel assembly (Figure 8, Item 1).
5. Install three washers (Figure 8, Item 4) and bolts (Figure 8, Item 3) on retainer (Figure 8, Item 2). Tighten bolts
to 26 lb-ft (35 Nm).
6. Remove lifting device and chains from rear tire wheel assembly (Figure 8, Item 1).
NOTE
Alternate between rotating wheel and tighten bolts. Rotate wheel at least on revolution
between bolts.
7. While rotating rear tire wheel assembly (Figure 8, Item 1), tighten three bolts (Figure 8, Item 3) to 52 lb-ft
(70 Nm).
8. Using depth micrometer (Figure 8, Item 4), measure depth at two smaller holes on retainer (Figure 8, Item 2).
Average measurements and record measurement.
9. Install suitable chains and lifting device on rear tire wheel assembly (Figure 8, Item 1).
10. Remove three bolts (Figure 8, Item 3), washers (Figure 8, Item 2), and retainer (Figure 8, Item 2) from rear tire
wheel assembly (Figure 8, Item 1).
11. Using caliper, measure thickness of retainer (Figure 8, Item 2) near two smaller holes. Average measurements
and record measurement.
0371-10