TM 5-3805-296-23-1
0064
Table 1. 0700 Transmission Gear Position Sensor Diagnostic Codes Continued.
064
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
Tractor Actual Gear Switch Damaged
5. Inspect tractor actual gear switch
0700-02 Transmission Gear
Replace tractor actual gear switch
for damage IAW (WP 0273) and
Sensor Erratic, Intermittent,
(WP 0273).
Electrical General Maintenance
or Incorrect Continued
Proceed to Test Step 20.
Instructions (WP 0540).
No Problem Found Proceed to Test
Step 2.
Test Step 2. Test Voltage to Tractor
Actual Gear Switch.
1. Connect connector A-C9
(WP 0012, Figure 122) to
connector AG-C2
(WP 0012, Figure 121).
2. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-296-10).
NOTE
Diagnose and repair any circuit found to have voltage greater than 12.5 V
before diagnosing other circuits.
3. Using digital multimeter
Voltage Greater Than 12.5 V at Any
(WP 0540), test for voltage
Test Point Proceed to Test Step 3.
between the following:
Voltage 11.2 to 12.5 V at All Test
a. Connector AG-C1 terminal 9
Points Proceed to step 4.
and terminal 10
Voltage Less Than 11.2 V at Any Test
(WP 0012, Figure 120).
Point Proceed to Test Step 7.
b. Connector AG-C1 terminal 7
and terminal 10
(WP 0012, Figure 120).
c.
Connector AG-C1 terminal 6
and terminal 10
(WP 0012, Figure 120).
d. Connector AG-C1 terminal 4
and terminal 10
(WP 0012, Figure 120).
e. Connector AG-C1 terminal 3
and terminal 10
(WP 0012, Figure 120).
f.
Connector AG-C1 terminal 1
and terminal 10
(WP 0012, Figure 120).
4. Using digital multimeter
Voltage 18 to 25 V Proceed to Test
(WP 0540), test for voltage
Step 6.
between connector AG-C1
Voltage Less Than 18 V Proceed to
terminal 2 and terminal 10
Test Step 18.
(WP 0012, Figure 120).
0064-3