TM 5-3805-296-23-1
0063
Table 1. 0673 Transmission Speed Sensor Diagnostic Code Continued.
063
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0673-02 Speed Sensor 2
Test Step 17. Test Transmission
Incorrect Signal Continued Wiring Harness for High Resistance
or Open.
1. Connect jumper wire between
terminal 1 and terminal 2
of connector A-C17
(WP 0012, Figure 118).
2. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 18.
between connector A-C1
Resistance Greater Than 5.0 Ohms
terminal 39 and terminal 40
Replace transmission wiring harness
(WP 0012, Figure 106).
(WP 0266).
Proceed to Test Step 22.
Test Step 18. Test for Shorted
Chassis Wiring Harness.
1. Remove jumper wire from terminal
1 and terminal 2 of connector
A-C17 (WP 0012, Figure 118).
2. Disconnect connector J-C8
(WP 0012, Figure 100)
from connector W-C1
(WP 0012, Figure 99).
3. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C3
Proceed to Test Step 22.
terminal 40 (WP 0012, Figure 101)
No Continuity Proceed to step 4.
and all other terminals
in connector J-C3
(WP 0012, Figure 101).
4. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8 terminal 2
Proceed to Test Step 22.
(WP 0012, Figure 100) and all
No Continuity Proceed to step 5.
other terminals in connector J-C8
(WP 0012, Figure 100).
5. Using digital multimeter
Continuity Replace chassis wiring
(WP 0540), test for continuity
harness (WP 0305).
between connector J-C8 terminal 2
Proceed to Test Step 22.
(WP 0012, Figure 100) and
No Continuity Proceed to Test
ground.
Step 19.
0063-11