1
2
TM 9-4940-568-34
7-13
Make sure oil holes are clean. A
0.128 in. (3.25 mm) diameter rod
must be able to pass through oil
holes. Failure to follow this
procedure could cause damage to
equipment.
(4)
Using a large drift and hammer, expand
camshaft expansion plug (1) and drive it
flush with cylinder block (2).
e.
Follow-On Maintenance:
Install engine oil pan and suction tube, (TM 9-4940-568-20).
Install piston and connecting rod assemblies, (Para 7-6).
Install cylinder head and gaskets, (Para 7-4).
Install camshaft, (Para 7-7).
Install front gear housing, (Para 7-9).
Install crankshaft, (Para 7-5).
Install crankshaft rear seal, (Para 5-20).
Install lube oil pump, (Para 5-13).
Remove engine from stand, (Para 7-2).
END OF TASK