TM 9-4940-568-34
5-154
5-23. STARTER MOTOR REPAIR (CONT).
The preformed packing can
easily be damaged during
installation of the commutator
end frame. To prevent such
damage, install preformed
packing as described in the
following steps.
(12)
Install preformed packing (8) on frame and
field assembly (9).
(13)
Carefully roll preformed packing (8) out of
its normal installed position up on the
major OD of the frame and field assembly
(9). Allow preformed packing to remain in
this position until commutator end frame
(5) is partially installed.
(14)
Align marks on commutator end frame (5)
and field and frame assembly (9) made
prior to disassembly.
(15)
Start commutator end frame (5) on frame
and field assembly, leaving a gap just
slightly larger than the thickness of
preformed packing (8).
(16)
Using a scribe or similar tool, align tapped
holes in brush holder assembly (7) with
screw holes in commutator end frame (5).
7
9
8
5