TM 9-4940-568-34
5-86
5-16. FUEL INJECTOR REPLACEMENT (CONT).
b.
Disassembly.
(1)
Remove copper seal (13) from injector (2).
Discard copper seal.
c.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC
and flammable. Wear protective goggles,
face shield, and gloves; use only in a
well-ventilated area; avoid contact with
skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame.
Never smoke when using solvent. The
flashpoint for Type II Drycleaning Solvent
is 140 degrees F (60 degrees C) and Type
III Drycleaning Solvent is 200 degrees F
(93 degrees C). Failure to do so may result
in injury or death to personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin
or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with
water and get immediate medical attention.
(1)
Clean all metal parts with drycleaning
solvent.
(2)
Clean injector nozzle bore.