Table 2-21. Crane Troubleshooting (CONT).
TEST OR INSPECTION
3. BOOM LIGHT DOES NOT WORK IN THE MID POSITION.
Make sure the FRS 24 VDC electrical system is functioning properly.
Loosen four screws and clamps and open crane junction box cover and check for 24
VDC on right side of crane terminal strip position 18 and a known good ground.
If voltage is present, go to Test 2.
If no voltage is found, replace boom light switch. Refer to paragraph 5-4 in this
Check for voltage on left side of terminal strip position 6 and a known good ground.
If no voltage is found, replace resistor mounted on back of crane junction box.
Refer to paragraph 5-14 in this manual.