TM 9-2330-359-14&P
4-32. CAMSHAFT REPLACEMENT (ALL EXCEPT M872A3) (Con’t).
2.
3.
4.
Remove two preformed packings (14 and 16) and washer (17) from camshaft (18). Discard preformed packings.
Drive bushing (15) out of spider (13). Remove lubrication fitting (1) from spider.
Remove four nuts (10), lockwashers (9), screws (2), retainers (3 and 8), two O-rings (4), and bushing (5) from
bracket (7). Remove lubrication fitting (6) form retainer (3). Discard lockwashers and O-rings.
b. CLEANING AND INSPECTION
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles
and gloves, and use only In a well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near open flame or excessive heat.
The solvent’s flash point is 100°F-138°F (38°C-59°C). If you become dizzy while
using cleaning solvent, immediately get fresh air and medical help. If solvent contacts
eyes, immediately wash your eyes and get medical aid.
1.
Clean parts with dry cleaning solvent. Use wire brush to remove caked on dirt and corrosion. Replace parts if
defective.
TA706579
4-50
Change 2
