TM 9-2330-324-14&P
0038 00-5/6 blank
BLEEDING BRAKE SYSTEMContinued
0038
00
PRESSURE BLEEDINGContinued
16.
Master cylinder (8) should be approximately 3/4 full. Add brake fluid as necessary.
17.
Remove two cotter pins (16) and master pins (17). Discard cotter pins.
18.
Move inner casing (15) slowly back and forth while watching inside of master cylinder (8) being
careful not to pull inner casing out of actuator. Continue movement back and forth several times until
no air bubbles are visible in master cylinder.
19.
Install two master pins (17) and new cotter pins (16).
CAUTION
Do not use any tool to tighten filler cap (7)finger-tighten only.
Failure to follow this caution could result in damage to equipment.
20.
Install filler cap (7) on master cylinder (8).
21.
Install cover (5) and two screws (6).
6
17
8
5
7
15
16
END OF TASK