TM 9-2330-238-14
5-14. LANDING
GEAR ACTUATING
LEG ASSEMBLY REPAIR (EARLY MODEL)
(Con’t).
12.
13.
14.
15.
16.
17.
Install two plugs (2) in end of outer leg assembly (3),
with first plug against flat surface of inner leg (31). The inner
plug should be loose enough to allow the inner leg to move in and out freely, but tight enough to keep in from
rotating.
Start drive shaft (5) through opening in outer leg (3) and install woodruff key (17), bevel gear (18), and flat washer
(10) on drive shaft.
Push drive shaft (5) in outer leg assembly (3)
so approximately
same length of the shaft extends on each side of
outer leg assembly.
Install one new spring pin (6) to secure bevel gear (18), then install other new spring pin (6) against washer (10).
Lubricate bevel gears (9 and 18) and bearings (8 and 21) in accordance
with Lubrication
Instructions
(Chapter 3,
Section
I).
Install new gasket (12) and access cover (13) on top of outer leg (3) with two screws (14)
and two screws (15).
FOLLOW-ON
TASKS:
l
Install and adjust landing gear (para 5-11).
5-42
