4-76. PREPARATION OF EQUIPMENT FOR ADMINISTRATIVE STORAGE (Cont).
b. Storage Plan.
(1) Store equipment so as to provide maximum protection from the elements and to provide access for
inspection, maintenance, and exercising, Anticipate removal or deployment problems and take suitable precautions.
(2) Take into consideration environmental conditions, such as extreme heat or cold; high humidity;
blowing sand, dust, or loose debris; soft ground; mud; heavy snows; earthquakes; or combinations thereof, and take
(3) Establish a fire plan and provide for adequate firefighting equipment and personnel.
c. Maintenance Services and Inspection.
(1) Maintenance Services. Prior to storage, perform the next scheduled organizational PMCS.
(2) Inspection. inspect and approve equipment prior to storage. Do not place equipment in storage in a
d. Auxiliary Equipment and Basic issue items.
(1) Process auxiliary equipment and basic issue items simultaneously with the major item to which they
(2) If possible, store auxiliary equipment and basic issue items with the major item.
(3) If stored apart from the major item, mark auxiliary equipment and basic issue items with tags
indicating the major item, its registration or serial number and location, and store in protective type closures. in
addition, place a tag or list indicating the location of the removed items in a conspicuous place on the major item.
e. Correction of Shortcomings and Deficiencies. Correct all shortcomings and deficiencies prior to
storage, or obtain a deferment from the approving authority.
Lubrication. Lubricate equipment in accordance with instructions in Chapter 3, Section I.
g. General Cleaning, Painting, and Preservation.
Do not direct water or steam, under pressure, against unsealed electrical systems, fire
control instruments, or any exterior opening which will damage a component.
(1) Cleaning. Clean the equipment of dirt, grease, and other contaminants, but do not use vapor
decreasing. Remove foreign objects that are wedged between wheels.
(2) Painting. Remove rust and damaged paint by scraping, wire brushing, sanding, or buffing. Sand to a
smooth finish and spot paint as necessary (TB 43-0209).
(3) Preservation. After cleaning and drying, immediately coat unpainted metal surfaces with an oil or
grease, as appropriate (Chapter 3, Section I).
Place a piece of barrier material (item 2, Appendix E) between desiccant bags and
Air circulation under draped covers reduces deterioration from moisture and heat.
(4) Weatherproofing. Sunlight, heat, moisture (humidity), and dirt tend to accelerate deterioration.
install all covers (including vehicle protective closures) authorized for the equipment. Close and secure all openings
except those required for venting and draining. Seal openings to prevent the entry of rain, snow, or dust. insert
desiccant when complete seal is required. Place equipment and provide blocking or framing to allow for ventilation
and water drainage. Support cover away from item surfaces which may rust, rot, or mildew,