Always keep lubricant compartments at least 3/4 full.
TYPE OF LUBRICANT
Engine Oil Compartment
OE/HDO 15/30-40 (0-1236)
GAA (F) (G-403)
Gear Lube Compartment
Open the ball valve (14) on transfer pump assembly to required air volume.
Fill lubricant compartments in lube tank (8) to capacity indicated in LUBRICANT TABLE above.
When compartment (8) is filled, close ball valve (14) on transfer pump assembly.
Disconnect air service hose (11) and reel it back onto center reel assembly (12).
Remove transfer pump hose assembly (9) from transfer pump (4), and drain any remaining lubricant
back into drum. Remove transfer pump hose assembly (9) from drum; clean and store in tool box
Clean and store transfer pump (4) in original position.
Using bung wrench (5) re-install plug into drum; clean and store bung wrench (5) in lower drawer of
reel cabinet assy (6).
Shut down engine by turning power switch (15) on control panel (16) to "off" position.
Open the condensate removal valve (1) to drain moisture from the air receiver tank (2).