TM 5-4930-244-14
Section III. UNIT TROUBLESHOOTING PROCEDURES
4-7. INTRODUCTION
a.
This table lists common malfunctions that you may find with your equipment. Perform the tests, inspections, and
corrective actions in the order they appear in the table.
b.
This table cannot list all the malfunctions that may occur, all the tests and inspections needed to find the fault, or
all the corrective actions needed to correct the fault. If the equipment malfunction is not listed or actions listed do
not correct the fault, notify your supervisor.
NOTE
Before you use this table, be sure you have performed your PMCS (Chapter 2,
Section II) Prior to performing unit troubleshooting procedures, be sure that
Operator Troubleshooting Procedures have been performed
4-8. MALFUNCTION INDEX
Malfunction No.
Malfunction
Page
1.
Engine Will Not Start ....................................................................................................4-5
2.
Engine Stops During Normal Operation .........................................................................4-6
3.
Engine Misfires During Operation ..................................................................................4-6
4.
Engine Oil Pressure is Too Low or High At Normal Operating Conditions .........................4-6
5.
Diesel Fuel Is Used Too Quickly ...................................................................................4-7
6.
Lube Dispensers And Pumps Are Not Operating Properly ..............................................4-7
4-4