TM 5-3825-230-14&P
2-8. OPERATING PROCEDURES (CONT).
d.
Brush Angle Adjustment. Brush angle can be selected to windrow sweepings to either the right or left of the
sweeper. Selection of brush angle is largely dependent upon width of surface to be swept and the pattern used to sweep
the surface.
Always set hand brakes before performing this adjustment procedure or injury to personnel may result.
(1)
Raise brush (1) and shut down engine.
(2)
Remove angle securing pin (2) and swing brush (1) to desired angle.
(3)
Replace pin (2) in hole on opposite side the brush (1) is pointing.
2-18