5-41. HYDRAULIC CONTROL VALVE REPAIR (CONT).
Disassemble control valve as follows:
Remove three flat washers (16).
Remove control valve spool (17).
Remove detent retainer (18), lockwasher (19), and detent sleeve (20) as one piece using a flat tip
Steel balls and springs in detent retainer are under extreme pressure and may come out with
velocity. Wear eye protection during this procedure.
Remove detent retainer (18) from detent sleeve (20).
Remove four steel balls (21) and two springs (22).
Remove retainer (23).
Tag valve spool (17) and remove two O-rings (24).