GOVERNOR CONTROL LEVER ASSEMBLY REPLACEMENT/REPAIR (CONT).
Make sure that fork fits on slide knob
of injector pump.
Install governor control assembly (4), support
(3), two lockwashers (2), and two screws (1)
using a 6 mm hex head wrench.
Connect spring (5) to pin (6
Push governor control lever (1) all the way right.
Pin (2), located on lower governor control lever
(1), must just make contact with pin
that connects governor control lever with lower
speed governor lever (4).
Adjust by turning screw (5) using a 6 mm hex
Follow-on maintenance: Install throttle control assembly (para 5-28)
END OF TASK