Be sure to matchmark oil pump housing in relation to crankcase before removal to ensure
correct installation. Holes in oil pump must align with oil flow holes in crankcase.
Remove two screws (4), two washers (5), and oil pump assembly (6) from crankcase (7) using a ratchet and 13
Coat pump housing with fresh engine oil and install pump assembly (6) in crankcase (7).
Install two washers (5) and two screws (4). Tighten to 66 lb-in (7.4 Nm) using a ratchet and 13 mm socket.
Install gear wheel (3), washer (2), and nut (1). Tighten to 92 lb-in (10.4 Nm) using a ratchet and 17 mm socket.
Follow-on maintenance: Install rear engine housing (para 5-12)
END OF TASK