THE KELLY BAR SHOULD NEVER BE USED TO PUSH THE
TRUCK IN THE EVENT IT BECOMES STUCK OR DISABLED.
A BENT KELLY BAR IS USUALLY THE RESULT OF SUCH
Operating the collapsible wire reel.
The wire reel is designed to be mounted onto the end of the winch assembly shaft. It must be secured
to the winch shaft using the clevis pin and hair pin provided for this purpose.
With the wire reel mounted horizontally onto the winch shaft, position the handle in the horizontal
position to wind cable. To remove cable, position handle perpendicular to the winch shaft.
MOVING THE UNIT TO NEW DIGGING SPOT, SAME WORK-SITE
Before moving the digger, raise the auger and lower the feed ram to the traveling position. Raise support jack
and stop engine.
BEFORE AND DURING LOWERING OF THE FEED RAM,
LINE UP THE DOTTED LINE ON FRAME RING TO MARKER
ON THE RIGHT ANGLE DRIVE TO PREVENT FEED RAM
FROM DAMAGING ENGINE AND ACOUSTICAL PANEL.
MOVEMENT TO A NEW WORK-SITE
Short distance movement
If the earth auger is to be moved only a short distance, it will be moved on its carrier.
Refer to Page 10 and remove the auger from auger shaft.
BEFORE MOVING TO NEW SITE, SEE PAGE 10.
Stow auger and bit, all equipment and tools on the carrier.
Move carrier to new work-site.