Column Entries: Columns used in the Maintenance Allocation Chart are explained below:
a. Column 1, Group Number: Column 1 lists group numbers, the purpose of which is to identify components,
assemblies, subassemblies, and modules with the next higher assembly.
b. Column 2, Component/Assembly: Column 2 contains the noun names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
Column 3, Maintenance Functions: Column 3 lists the functions to be performed on the item listed in Column
d. Column 4, Maintenance Category: Column 4 specifies, by the listing of a "work time" figure in the appropriate
subcolumn (s), the lowest level of maintenance authorized to perform the function listed in Column 3. This figure
represents the active time required to perform that maintenance function at the indicated category of maintenance. If t' e
number or complexity of the tasks within the listed maintenance function vary at different maintenance categories,
appropriate "work time' figures will be shown for each category. The number of man-hours specified by the "work time"
figure represents the average time required to restore an item (assembly, subassembly, component, module, end item or
system) to a serviceable condition under typical field operating conditions. This: time includes preparation time,
troubleshooting time, and quality assurance/quality control time in addition to the time required to perform the specific
tasks identified for the maintenance functions authorized in the Maintenance Allocation Chart.
e. Column 5, Tools and Equipment: Column 5 specifics by code, those common tool sets (not individual tools)
and special tool, test, and support equipment required to perform the designated function.
Column 6, Remarks: Column 6 contains an alphabetic code which leads to the remark in Section IV,
Remarks, which is pertinent to the item opposite the particular code.