NATO SLAVE RECEPTACLE CABLE REMOVAL
Make sure battery disconnect switch is in OFF position before replacing NATO slave
receptacle and cables. Failure to follow this warning may result in injury or death to
personnel or damage to equipment.
Perform steps 1, 2, and 3 only if machine is equipped with arctic start aid.
Note cable routing to aid in installation.
Tag and mark all cables to aid in installation.
1. Position cover (Figure 5, Item 3) aside.
2. Remove bolt (Figure 5, Item 2) and washer (Figure 5, Item 1) from junction block (Figure 5, Item 5).
3. Remove negative arctic start aid battery cable (Figure 5, Item 4) from junction block (Figure 5, Item 5) and
Figure 5. Negative Arctic Start Aid Battery Cable at Junction Block.