TM 5-3805-296-23-5
0294
CLEANING AND INSPECTION
000294
Clean and inspect all parts IAW Mechanical General Maintenance Instructions (WP 0539).
END OF TASK
INSTALLATION
000294
1. Install new O-ring (Figure 3, Item 7) on front axle housing (Figure 3, Item 3).
2. Using assistance, attach sling and lifting device to front axle housing (Figure 3, Item 3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may result in injury or death to personnel.
NOTE
Install front axle housing as noted during removal.
Front axle weighs 485 lb (220 kg).
3. Using assistance and lifting device, install front axle housing (Figure 3, Item 3), 22 washers (Figure 3, Item 6),
and bolts (Figure 3, Item 5) on machine.
4. Remove two guide pins (Figure 3, Item 4) from front axle housing (Figure 3, Item 3).
5. Install two washers (Figure 3, Item 2) and bolts (Figure 3, Item 1) on front axle housing (Figure 3, Item 3).
6. Tighten 24 bolts (Figure 3, Items 1 and 5) to 330 lb-ft (447 Nm).
7. Using assistance, remove sling and lifting device from front axle housing (Figure 3, Item 3).
0294-5