TM 5-3805-296-23-2
0065
Table 1. 0702 Shift Lever Position Sensor Diagnostic Codes Continued.
065
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
3. At MSD, check for active
702-4 Transmission Gear Lever
0702-04 Transmission Gear
Selector Sensor (Switch) Voltage
diagnostic codes (WP 0008).
Lever Selector Sensor
Below Normal Becomes Inactive
(Switch) Voltage Below Nor-
Proceed to step 4.
mal Continued
702-4 Transmission Gear Lever
Selector Sensor (Switch) Voltage
Below Normal Remains Active
Repeat troubleshooting from the
beginning.
4. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-296-10).
5. Install right trim panels on ROPS
(WP 0494).
6. Troubleshooting complete.
NOTE
0702-08 Transmission Gear
Lever Selector Sensor
Always inspect harness connectors that are involved in the circuit. Poor
(Switch) Abnormal Signal
connections can often be the cause of a problem in an electrical circuit.
Verify that all connections in the circuit are clean and secure and that all
connections are in good condition. If a problem with the connection is
found, correct the problem and verify that this malfunction or diagnostic
code is active before performing this procedure.
Perform open or short-circuit test at each harness connection to identify
the correct harness to replace.
Tag all wiring harnesses to aid in installation.
Perform this test only if condition is active.
DIAGNOSTIC CODE SET CONDITION
Transmission/Chassis ECM Detects an Invalid Input From Transmission Shifter
Circuit M997.
POSSIBLE CAUSE
Fuse Panel Wiring Harness High Resistance or Open.
Implement Control Joystick.
Transmission/Chassis ECM.
0065-9