TM 5-3805-296-23-1
0024
Table 1. 0168 System Voltage Diagnostic Codes Continued.
024
CID FMI
TEST OR INSPECTION
CORRECTIVE ACTION
0168-01 Electrical System
5. Remove jumper wire from
Voltage Low Continued
terminal 11 and terminal 18
of connector CL-C3
(WP 0012, Figure 86).
6. Connect jumper wire between
terminal 18 and terminal 20
of connector CL-C3
(WP 0012, Figure 86).
7. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to Test Step 9.
between connector CL-C1
Resistance Greater Than 5.0 Ohms
terminal 52 and terminal 53
Replace engine interface wiring
(WP 0012, Figure 45).
harness (WP 0211).
Proceed to Test Step 10.
Test Step 9. Test Main Cab Wiring
Harness for Open.
1. Remove jumper wire from
terminal 18 and terminal 20
of connector CL-C3
(WP 0012, Figure 86).
2. Disconnect connector CG-C1
(WP 0012, Figure 283)
from connector W-C8
(WP 0012, Figure 282).
3. Connect jumper wire between
terminal 11 and terminal 18
of connector W-C16
(WP 0012, Figure 87).
4. Using digital multimeter
Resistance 5.0 Ohms or Less
(WP 0540), measure resistance
Proceed to step 5.
between connector W-C8
Resistance Greater Than 5.0 Ohms
terminal 27 and terminal 28
Replace main cab wiring harness
(WP 0012, Figure 282).
(WP 0505).
Proceed to Test Step 10.
5. Remove jumper wire from terminal
11 and terminal 18 of connector
W-C16 (WP 0012, Figure 87).
6. Connect jumper wire between
terminal 18 and terminal 20 of
connector W-C16
(WP 0012, Figure 87).
0024-9