TM 5-3805-296-23-1
0011
FLASH PROGRAMMING CONTINUED
NOTE
If any error messages are received during flash programming, click "Cancel" to stop the
process. Verify that the file and component (engine, transmission, implement) match.
Repeat steps until flash programming is completed and the "Flash Completed
Successfully" screen displays.
19. Select CAT ET from button options.
NOTE
If you are flash programming ECM as directed by troubleshooting, proceed to next step. If
replacing an ECM, proceed to Copy Configuration To ECM in this work package.
20. Start and run engine until operating temperature is reached and verify proper operation of all components
(TM 5-3805-296-10). Check for active diagnostic codes by selecting Active Diagnostic Codes from the
Diagnostics menu.
END OF TASK
INITIALIZING ECM
00011
NOTE
Two ignition switch ON/OFF cycles are required for correct initialization of new ECM.
1. Turn battery disconnect switch to ON position (TM 5-3805-296-10).
2. Turn ignition switch to ON position (TM 5-3805-296-10).
3. Wait one minute to allow ECM to initialize.
4. Turn ignition switch to OFF position (TM 5-3805-296-10) and wait ten seconds.
5. Turn ignition switch to ON position (TM 5-3805-296-10).
ET will indicate whether ECM has been programmed or not.
If ECM is not programmed, program ECM using WinFlash software contained within ET. Proceed to
FLASH PROGRAMMING in this work package.
If ECM is programmed, ET will allow access to ECM to load configuration data. Proceed to Copy Configu-
ration to ECM in this work package.
END OF TASK
0011-18